SPRO BBZ QUESTION

KMAC · Post by **KMAC** » Sat Feb 02, 2008 10:18 am

I like the way the BBZ (floater) swims as a subtle wake bait. Maybe because I have"nt got bit, I am uncomfortable with the rattles. I am thinking of removing the "ball bearing" sounding balls and replacing them with some clay as not to throw fo the balance. Before I start sugery, has anybody got any advice ?

Drill motor in hand.

littlebailey · Post by **littlebailey** » Sat Feb 02, 2008 10:47 am

Drill that bad boy to pieces!

Morris · Post by **Morris** » Sat Feb 02, 2008 11:30 am

yes it works with out the rattles, took them out and got more
strikes on the bait, trout don't have rattles on them do they?

mark poulson · Post by **mark poulson** » Sun Feb 03, 2008 8:35 am

How'd you patch the holes after you drilled it?

KMAC · Post by **KMAC** » Mon Feb 04, 2008 5:24 pm

I was thinking of removing the rubber tail then opening the last section with a drill or exacto. Then remove the rattles, spackle up the damage,then re-glue the tail to hide any imperfections.

mm · Post by mm » Wed Feb 06, 2008 8:48 am

If you remove the rattles, you will still have noise coming from the hinges,squeaking mostly.
If you know someone that has neutered their BBZ, you may want to borrow it to see the noise difference.
Any bait with hinges is never going to be totally silent.

mark poulson · Post by **mark poulson** » Wed Feb 06, 2008 3:58 pm

If you want to fish it fast, the rattles/hinge noises just help, because it's pure reaction.
If you plan to fish it slow, I still think the noise is an attactor. There are plenty of other swimbaits without rattles.